Setting up Vineyard or Orchard Row Polygons
Auto-create a layer of row polygons
Roger Wiese
Last Update hace 16 días
agCommander can display a map report of the rows that were treated or dealt with for a job - when you have enabled data entry by row in the System Setup > Organization > Business Unit configuration and then followed the steps outlined below.
Setting up your row polygons
When you have set up the Perennial Crop Layout information for a Vineyard block or Orchard, you will see this button...
Before you can use the auto-create row polygon feature, you must have drawn or imported either the block polygon (if there is only one perennial cropped area for the block) or the perennial cropped area polygon.
Or put another way -
If you have only one perennial cropped area for each block, then you only need to draw or import the block polygon.
If you have multiple perennial cropped areas for a block, then obvioulsy you're going to need one polygon per perennial cropped area.
This is how it works.
1.You click your mouse on one of the edges of the polygon. The edge you click MUST BE parallel with the rows of trees or vines. You will see the edge you clicked on will display as a red line.
2. You then nominate whether that edge you clicked on is at the First Row or the Last row of the block. This is important because each row polygon will be stored in the relevant row's record.
3. You then click the Apply button and the appropriate number of polygons will be created - 1 per row.
See the image after the one below
If you need to start again, click the Reset button. If you want to exit without saving, click the Cancel button.
Click Save to keep the information in memory ready to finally push the new polygons to the cloud.
PLEASE NOTE: To save the new polygons to the cloud, you have to click on the Save button on the next form
If you want to view the row polygons at any time, use the "View Row Polygons on Map" button. See image below this one.
See below - Viewing your row polygons. If you want to change them, use the Reset Row Polygons button
Where to see the row polygons in action
When using the Job Details viewer you will see an option the Show Job Rows
By choosing that option, the report will show you just the rows treated or dealt with
There are 2 tabular reports that will show which rows were involved in a job. See below.
